DB-3
The DB-3 went into production at Plant No. 39 in Moscow and
Plant No. 18 in Voronezh. To perfect the bomber during series production, Plant
No. 39’s experimental workshop was transformed into a design bureau, with
Sergei Ilyushin as chief designer. This was simply a formality, because by that
time the Ilyushin OKB had already been formed as a united team of designers
capable of solving different problems concerning the development and updating
of advanced combat aircraft.
From May to October 1937 pre-production DB-3 No. 3039002
underwent state tests at the Nauchno Issledovatelyskii Institut (NIl –
scientific and research institute of the WS). Its performance proved to be
slightly inferior to that of the prototype. At a weight of 14,550lb (6,600kg)
it had a sea level speed of 201mph (325km/h), attained 242mph (390km/h) at
16,400ft (5,000m) and reached its service ceiling in 46 minutes. With such a
performance the DB-3 considerably outperformed Germany’s Junkers Ju86D and even
the new Heinkel He 111B then under test at Rechlin. The He 111B was 6.2 to
12.4mph (10 to 20km/h) slower at all altitudes and its service ceiling was
4,600ft (1,400m) lower, while its armament was the same and controllability and
stability were better.
Not only were the DB-3’s aerodynamics excellent, but its
fuel and oil capacity were equal to one-third of its maximum take-off weight.
As a result it had ranges of 2,485 miles (4,000km) with a 1,102lb (500kg) bomb
load and 1,926 miles (3,100km) with a bomb load of 2,204lb (1,000kg), while the
He 111B managed 1,031 miles (1,660km) with 1,653lb (750kg) and 565 miles
(910km) with 3,306lb (1,500kg). Early in its successful life the DB-3 gained
the high appreciation of its pilots. Particularly notable were its ease to
take-off, rapid climb, good stability without any suggestion of yaw, steady
level flight (which made it a good bombing platform), tight turns with 40* to
60* of bank, and easy landing approach. It had no dangerous tendencies such as
rapid loss of speed, wing stall and arbitrary ballooning during landing. The
DB-3 also had good single-engine capabilities, and at a normal flying weight of
15,4321b (7,000kg) could climb and turn in both directions on one engine.
However, pilots noted a lack of longitudinal stability owing to the generally
accepted aft cg position.
In 1937, with the help of a number of Ilyushin Design Bureau
designers including A Belov, V Biryulin, M Yefimenko and A Levin, the two
plants manufactured 45 DB-3s, and that year the bomber was introduced into the
inventory of the Soviet WS. It considerably outperformed similar bombers built
in Germany, England, France and the USA.
Its high performance, especially with regard to range, was
proved during two long range flights made by the modified TsKB-30, now named
Moskva, during 1938-1939. On one of these, flown on 28/29th April 1939, pilot V
Kokkinaki and navigator M Gordienko covered 4,971 miles 8,000km (4,048 miles/
6,515km in a straight line) non-stop at an average speed of 216mph (348km/h).
This was a significant achievement for Soviet aviation at that time. The
Moskva’s long-distance flights greatly influenced the development of the DB-3’s
airframe, engines and equipment. Moreover, flights by Kokkinaki and many other
Soviet pilots enabled piloting techniques for long range flights to be
developed and revealed the crew fatigue limits. These aspects also promoted
efficient weather survey and communication services.
All of this elevated the combat capabilities of Soviet
long-range aviation, based at that time on different variants of the DB-3,
which was constantly being improved. In 1938 the M-85 engine was replaced by
the M-86 with an augmented rating of 950hp (708kW). This allowed the DB-3’s
good take-off performance to be retained in spite of increased weight. The
maximum speeds at various altitudes remained the same. From 1938 the bomber’s
speed was increased by the installation of M-87As and the use of VISh-3
variable-pitch propellers instead of fixed-pitch units, which meant that engine
power was used to best advantage during different phases of flight. The M-87A,
which had the same take-off power as the M-86, provided 800hp (596kW) at an
altitude of 15,500ft (4,700m).
During tests at the NII WS early in 1939, two bombers
produced at Plants Nos. 18 and 39 demonstrated improved performance. At a
flying weight of 15,873 to 17,1951b (7,200 to 7,800kg) their sea level speeds
were equal to 265 to 270mph (428 to 436km/h) at a critical altitude of 16,300ft
(4,960m). The service ceiling had increased to 30,200 to 30,500ft (9,200 to
9,300m), and the time to climb to 16,400ft (5,000m) was 10.7 minutes. The
take-off run was 1,148 to 1,312ft (350 to 400m) and the maximum overloaded
weight had risen to 21,3751b (9,696kg). In the final test report it was noted
that the aeroplanes produced by Plant No. 39 were of higher quality. In 1938
another factory, No. 126 in Komsomolsk, was also converted to DB-3 production,
increasing output by 400 aircraft.
DB-3T and DB-3TP
The Ilyushin Design Bureau constantly extended the
applications of the DB-3, and the DB-3T variant of 1937 was used as a naval
torpedo bomber. By virtue of special external attachment points it could carry
a 45-36 type torpedo (the first number denoted the torpedo’s calibre in
centimetres, the second its year of introduction into the inventory) with a
440lb (200kg) warhead and a total weight of 2,072lb (940kg). The DB-3T (T –
torpedonosyets, torpedo) was equipped to enable the missile to be dropped using
either low or high torpedo bombing methods. In the first case the 45-36 AN low
altitude aerial torpedo was dropped from 100ft (30m) at a speed of 198mph
(320km/h). It was forbidden to drop the torpedo lower or higher because its
casing could be cracked when it hit the water or it could sink too deep.
Although low altitude torpedo bombing offered the highest probability of
destroying the target, it demanded a high degree of piloting skill and good
aircraft handling and manoeuvrability. In high altitude torpedo bombing the
DB-3T dropped the torpedo from 1,000ft (300m). The missile was parachuted down,
and when it touched the water it began to travel in a circle on the target’s
course. In addition to its torpedo, the DB-3T could carry the usual bomb load,
and could be used as a bomber or for dropping mines. It could also serve as a long-range
naval reconnaissance aircraft.
Introduced into the USSR Naval Aviation inventory, the D8-3T
became the first mass produced Soviet torpedo-bomber, fully meeting the
operational requirements. On its technical basis a new aspect of Naval
Aviation, Torpedo Aviation, was born in 1939-1940 for the destruction of enemy
vessels by torpedoes and bombs, and also for mining enemy seaways and exits
from naval bases.
However, the DB-3T could take off only from land bases, and
sometimes these were not readily available, especially in the areas covered by
the Northern Fleet. In 1938, therefore, a new version, the DB-3TP
(Torpedonosyets Poplavkovyi – torpedo floatplane) was designed. The floats,
taken from the Tupolev TB-1 P, naturally reduced the torpedo-bomber’s
performance. During tests in the summer of 1938 at a normal flying weight of
16,644lb (7,550kg) and carrying a torpedo, the DB-3TP reached a speed of 213mph
(343 km/h) at 13,100ft (4,000m), and its climb rate and service ceiling were
also reduced. Even this performance met estimated requirements and was better
than the Beriev MDR-5 and Chyetverikov MDR-6 flying-boats. The DB-3TP retained
the type’s good handling.
Test pilot Sukhomlin assessed the seaplane thus: ‘The
aircraft is well-produced as a torpedo-bomber and naval high-speed bomber. It
is fully suited to these roles’. Nevertheless, the DB-3TP was not put into
series production owing to operational complications. It was very difficult to
load bombs, attach torpedoes and service the engines while the aircraft was on
the water.
Variants
TsKB-26
Proof-of-concept
prototype
TsKB-30
First real
prototype. Later modified, including removal of armament, for long-range record
attempts as the “Moskva”. It flew from Moscow to Spassk-Dalny (7,580
km (4,710 mi)) in 24 h 36 min (an average speed of 307 km/h (191 mph)) mostly
at 7,000 m (23,000 ft) under control of Vladimir Kokkinaki and A. M.
Berdyanskij, then from Moscow to Miscou Island (New Brunswick, Canada) in 22 h
56 min. covering 8,000 km (5,000 mi) at 348 km/h (216 mph) average airspeed
(Kokkinaki and Mikhail Gordienko).
DB-3 2M-85
Initial production
model
DB-3 2M-86 (DB-3A)
Engines upgraded
to M-86, other minor changes
DB-3 2M-87A (DB-3B)
Engines upgraded
to the Tumansky M-87A
DB-3T
Torpedo bomber
built in 1938, with either the M-86 or M-87 engine, armed with 45-36-AN or
45-36-AV torpedoes.
DB-3TP
Seaplane torpedo
bomber built in 1938. No production.
DB-3M
First major
upgrade powered by two M-87B or M-88 engines.
